|
Trailer Wheel Bearings
Hi there. I am new to boating, having just bought a 14 foot day boat
and trailer last weekend. I have been checking over the trailer and I
dismantled the wheel bearings to check them. They are a pair of tapered
roller bearings, fitted to a hub with 'HG 505' marked on it. The thing
is, the hub has about 2mm slack when I tighten the hub nut fully. I
would have thought that there would be less play. Is the hub assembly
worn?
Any ideas on this would be much appreciated.Thanks Davy M. |
New2Boating
Mar 12
2006
|
| Not only that, but it should be a washer with some sort of
anti-rotation device. |
Gene
Mar 14
|
| Is there a washer at all? There should be. |
Chuck
Mar 12
|
| Hi James. The hub nut is butting up against the stub axle when
tightened. I would need to fit an oversized washer to slide over the
stub axle to tighten the bearings any further. I would probably have to
make the washers up to suit. Thanks for your input.
Davy M. |
New2Boating
Mar 12
|
| On every tapered wheel bearing I've worked on you can lock the bearings by
tightening. That is the normal adjustment, tighten and then back off
slightly. Is the hub nut bottoming out on the threads? Perhaps the washer
between the nut and the bearing is missing? If not I would try an extra
washer. "New2Boating" <davymurray@hotmail.com> wrote in message |
James
Mar 12
|
|
|
Disclaimer: This is a computer-generated and formatted feed of current postings to a public
Internet forum. We do not control the information delivered, nor do we endorse or monitor its
content. Internet forums may carry offensive, harmful, inaccurate, and otherwise inappropriate material.
|
|
