|
Tilt/Trim Motor Getting Extremly Hot, Bonding wires melting
My Tilt/Trim motor gets very hot after only cycling the engine the full
range a couple of times. also the bonding wires on my outboard are
getting extremly hot and melting the insulation. None of this occurs
on my other engine. I'm wondering if the motor ismessed up and is
shorting out... if so what do I replace? Armature, brushes, breaker,
springs??? Thanks |
amanda.lemons
Oct 5
2006
|
| Sounds like it is drawing too much. Since it's still working I'd check to
see if something is binding causing it to have to work harder before
suspecting the motor. <amanda.lemons@gmail.com> wrote in message |
James
Oct 6
|
| I had to replace the o-ring in teh trim cylinder, and this did not
start happening unil i ran the engine for a while bleeding the air,
only to find out i didnt have enough fluid in it to begin with. Could
a piece of teh o-ring be in there some where still, i did not see a way
for and pieces to go beyond the cylinder, and it was cleaned out before
i put the piston back in. Tim |
amanda.lemons
Oct 5
|
| Your T/T motor is pulling some serious amps. Swap it out.
JR
|
JR
Oct 5
|
| Check the basics first. Are you sure the motor is properly grounded? No |
snave
Oct 6
|
|
|
Disclaimer: This is a computer-generated and formatted feed of current postings to a public
Internet forum. We do not control the information delivered, nor do we endorse or monitor its
content. Internet forums may carry offensive, harmful, inaccurate, and otherwise inappropriate material.
|
|
