12 volt hydraulic pump?
Hi,Can someone point me in the right direction for finding a 12 volt
hydraulic pump that has low current draw, low flow rate, and pressure
around 500psi. I have run across quite a few large units. The type for
dump trailers etc, but they are way to big for my application.
It will need extend a 5/8" cylinder 12 inches at a rate of about 15
seconds. thanks for any info.
jim |
chapmjw
Dec 22
2006
|
| Have you tried Northern Tool?
http://www.northerntool.com/webapp/wcs/stores/servlet/category_6970_96 Tom J |
Tom
Dec 22
|
| Try McMaster-CARR http://www.mcmaster.com/ |
Sorobon
Dec 22
|
| If all else fails, it sounds like an old convertible top pump would suit
your needs. Mike |
Mike
Dec 22
|
| That was my thought but I am not sure there are that many of those
pumps around these days. |
gfretwell
Dec 22
|
| Check Hemming Motor News.
http://hemmingmotornews.com/ Lon |
Lon
Dec 22
|
| Those are being made new again for the restoration market. Pricy but
available. Year One would be a good place to start looking. John
---
John De Armond
See my website for my current email address
http://www.neon-john.com
Cleveland, Occupied TN
Don't let your schooling interfere with your education-Mark Twain |
Neon
Dec 22
|
|
Trim tabs on boats also have a 12volt pump |
Sorobon
Dec 22
|
| Dunno what your application is, but if it's on your vehicle consider
tapping into the power steering pump line, like the hydraulic winch
setups the 4x4 guys use. Pete |
ratatouillerat
Dec 22
|
